Spring Sale Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: pass65

  1. Home
  2. Cisco
  3. CCNP Service Provider
  4. 300-515
  5. Implementing Cisco Service Provider VPN Services (300-515 SPVI) Questions and Answers

300-515 Implementing Cisco Service Provider VPN Services (300-515 SPVI) Questions and Answers

Questions 4

Refer to the exhibit.

300-515 Question 4

What is shown in this output?

Options:

A.

local and outgoing abels are updated in hardware

B.

BGP is used between neighbors that are exchanging MPLS labels

C.

LDP neighbor statuses

D.

the labels received and advertised on PE1

Buy Now
Questions 5

Refer to the exhibit.

300-515 Question 5

An engineer has configured router 1 to provide shared services to clients behind router 2. To complete the implementation so that routes from router 1 are accepted, what must the engineer configure on router 2?

Options:

A.

with import route targets 101:102 and 202:201

B.

with import route targets 201:202 and 401:402

C.

with export route targets 301:202 and 101:102

D.

with export route targets 201:202 and 401:402

Buy Now
Questions 6

What do routers on the network use to avoid routing loops when OSPF is running as the PE-CE routing protocol on a service provider network?

Options:

A.

the AS-Override feature

B.

the DN bit with type 3, 5, or 7 LSA

C.

the domain tag for type 2 LSA

D.

sham links to create a super backbone over the service provider network

Buy Now
Questions 7

While troubleshooting an AToM L2VPN service, a network consultant notices that the AC Layer 2 encapsulations are different. Which action should the consultant take in order to make the MPLS L2VPN work?

Options:

A.

tag-rewrite on the ingress and egress PE router

B.

interworking IP configuration on the last PE router before label disposition

C.

nonrouted interworking setup to properly translate only the Layer 2 information from the AC

D.

interworking IP configuration on both the AC terminations on the PEs

Buy Now
Questions 8

An engineer is troubleshooting an EoMPLS circuit on a Cisco IOS XR router interface that removes a VLAN

Options:

A.

interface GigabitEthernet 0/10.l2transport

encapsulation dot1q 10

rewrite ingress tag pop 1 symmetric

l2vpn

xconnect group 103588

p2p 103588

interface GigabitEthernet 0/10.10

neighbor ipv4 10.10.10.2 pw-id 103588

B.

interface GigabitEthernet 0/10.10

encapsulation dot1q 10

rewrite ingress tag pop 1 symmetric

l2vpn

xconnect group 103588

p2p 103588

interface GigabitEthernet 0/10.10

neighbor ipv4 10.10.10.2 pw-id 103588

C.

interface GigabitEthernet 0/10.10 l2transport

encapsulation dot1q 10

l2vpn

xconnect group 103588

p2p 103588

interface GigabitEthernet 2/10.10

neighbor ipv4 10.10.10.2 pw-id 103588

D.

interface GigabitEthernet 0/10.10 l2transport

encapsulation dot1q 10

rewrite ingress tag translate 1-to-1 dot1ad 10

symmetric

l2vpn

xconnect group 103588

p2p 103588

interface GigabitEthernet 0/10.10

neighbor ipv4 10.10.10.2 pw-id 103588

Buy Now
Questions 9

A network architect is troubleshooting the L2TPv3 tunneling security due to the untrusted nature of the underlaying network. Which two L2TPv3 features does the architect deploy to address the ongoing issues? (Choose two.)

Options:

A.

TCP MD5 authentication

B.

control message hashing

C.

CHAP authentication

D.

control message rate limiting

E.

asymmetric mutual authentication with PSK

Buy Now
Questions 10

What do EVPN single-active and all-active have in common?

Options:

A.

They are default gateway redundancy options.

B.

They are multihoming mechanisms used for CE devices.

C.

They are used to provide single connection from a CE device to a service provider.

D.

They are both roles that a designated router can take when MPLS is used with EVPN.

Buy Now
Questions 11

300-515 Question 11

An engineer is trying to configure an EVPN VWPS. What is the issue with this configuration?

Options:

A.

The member in the VPWS context should be the PE-facing interface.

B.

The 12vpn evpn command should be instance 101.

C.

Interface GigabitEthernet0/1/0 should not have any IP address.

D.

The service instance and the EVPN instance are different.

Buy Now
Questions 12

300-515 Question 12

Which effect of this configuration is true?

Options:

A.

It configures VPWS multihomed.

B.

It configures VPWS single homed.

C.

It configures an IPv4 peering with 192.168.1.1

D.

It configures MPLS traffic engineering.

Buy Now
Questions 13

An engineer needs to improve MPLS network management by implementing a set of tools to support the NOC engineers in troubleshooting network failures. Which feature should the engineer implement to check the connectivity of the MPLS LSP between the ingress and egress PE routers?

Options:

A.

MPLS OAM

B.

MPLS-TP

C.

LDP autodiscovery

D.

extended ping

Buy Now
Questions 14

Which utility can you use to validate an LSP in an MPLS environment?

Options:

A.

uRPF

B.

MPLS LSP ping

C.

logging

D.

RSVP

Buy Now
Questions 15

While configuring the VRF Selection feature, you get an error message after typing the below statement:

Router(config)#no vrf selection source 172.16.0.0 255.255.0.0 v rf VRF1

Which action caused this message?

Options:

A.

the entry of an inconsistent IP address and mask for VRF Selection

B.

an attempt to configure a VRF instance on an interface that already has VRF Selection configured

C.

an attempt to remove a VRF Selection entry that does not exist

D.

an attempt to configure a VRF Selection table that does not exist

Buy Now
Questions 16

The CTO of a company requires the support of a network consultant to deliver an MPLS solution without resigning to a certain degree of redundancy and scalability. Which solution effectively scales to hundreds or thousands of sites?

Options:

A.

L2VPN with the broadcast traffic processed at the ingress PE.

B.

L3VPN with direct LSP connectivity between all PEs.

C.

L2VPN by encapsulating multiple frame formats with interworking.

D.

L3VPN using a hierarchical topology of N-PEs and U-PEs.

Buy Now
Questions 17

What is the primary function of a VRF on a router?

Options:

A.

It enables the router to support multiple separate routing tables, which allows the device to handle overlapping IP addresses.

B.

It enables a router to run BGP and a distance vector routing protocol at the same time, which allows it to serve as a VPN endpoint between remote sites.

C.

It enables a router to configure VLANs locally, which provides segregation between networks.

D.

It enables the router to provide faster switching through the network by using labels to identify the input and output interfaces for neighbor routers.

Buy Now
Questions 18

Which two BGP attributes prevent loops in a route reflector environment? (Choose two.)

Options:

A.

cluster ID

B.

local preference

C.

origin

D.

originator ID

E.

AS_PATH

Buy Now
Questions 19

Which BGP feature causes to replace the AS number of originating router with the AS number of the sending router?

Options:

A.

route reflectors

B.

route dampening

C.

confederations

D.

AS override

Buy Now
Questions 20

With Layer 3 MPLS VPN implementations on Cisco IOS XR PE routers, an interface is assigned to a VRF using the vrf command in which configuration mode?

Options:

A.

RP/0/RP0/CPU0:PE(config-bgp)#

B.

RP/0/RP0/CPU0:PE(config-if)#

C.

RP/0/RP0/CPU0:PE(config-bgp-af)#

D.

RP/0/RP0/CPU0:PE(config-vrf)#

Buy Now
Questions 21

You are writing the requirements for an MPLS L3VPN environment that uses MP-BGP between PE routers. In this environment, route targets and route distinguishers need to be advertised between the PE routers.

Which three operations meet these requirements? (Choose three.)

Options:

A.

mandatory creation of PE-to-PE BGP sessions between the outgoing interface IP addresses

B.

advertisement of standard communities, enabled on the PE-to-PE BGP neighbors

C.

creation of PE-to-PE BGP sessions between loopback IP addresses

D.

full mesh of IBGP sessions

E.

full mesh of EBGP sessions and partial mesh of IBGP sessions

F.

advertisement of extended communities, enabled on the PE-to-PE BGP neighbors

Buy Now
Exam Code: 300-515
Exam Name: Implementing Cisco Service Provider VPN Services (300-515 SPVI)
Last Update: Apr 30, 2026
Questions: 71

PDF + Testing Engine

$65.27  $186.49
buy now 300-515 pdf + testing engine

Testing Engine

$52.32  $149.49
buy now 300-515 testing engine

PDF (Q&A)

$48.12  $137.49
buy now 300-515 pdf