Which of the following statuses will be displayed when VMTracer has connected to vSphere?
What is the name of the link that connects two Arista switches together to form an MLAG domain?
When using Monitor Sessions with a destination of the CPU, it is impossible to forward an entire 10Gbps worth of traffic due to internal COPP policies. How might you successfully use this feature given these constraints?
Does Arista EOS firmware support U.S. Federal Information Processing Standards (FIPS) and Common Criteria (CC) security requirements?
Arista switches automatically issue a show tech support once every hour, saving the results to files on flash. How many of these files are retained by default?
Which command below is valid to use as a way to verify the status of the MLAG peer-link?
On an Arista 7150-24, which of the following commands would successfully help you to determine which ports would be subsumed within Ethernet1 configured at 40Gbps?
What is the name of the Arista EOS feature that allows you to view historical ARP table changes?
Which of the following commands will show the mac-address to VTEP table on an Arista switch?
What is the EOS feature that allows switches with Multi-Switch CLI enabled to send non-interactive commands to multiple switches at once?
Which command would you use to change the SSH Idle timeout after entering the ‘management ssh’ command?
Which of the following commands will show the currently running version of EOS?
When configuring MLAG, Arista recommends that the trunk group command be used on the VLAN used for MLAG peer communication. What is the purpose of the trunk group command?
Which of the following Arista switch series’ supports Zero Touch Provisioning (ZTP)?
What can you assume about Ethernet1 in this output from a 7150-24 that have been configured with the tap aggregation mode exclusive command?

How many line card slots are reserved for supervisors on the Arista 7300 series chassis switches?
On an Arista switch, what two commands can you use to write your changes from the running-configuration to the startup-configuration?
True or False: Arista MLAG requires a second Peer-Keepalive link to be cabled between the switches in the MLAG domain.
The VXLAN spec allows for two implementation types. One uses multicast. What is the other one called?
Which of the following commands can you use to see which EOS versions are stored on the switch’s flash drive (assuming a freshly booted switch)?