D-AV-DY-23 Dell Avamar Deploy 2023 Exam Questions and Answers

What is the lowest Dell Avamar Virtual Edition version that will support an average daily change rate of 1.5 GB in a file server environment?

You are checking the network cabling on a multi-node Dell Avamar Gen4 Data Store. Which port should be used to connect the utility node to the first switch?

An Dell customer is using Dell NetWorker and Data Domain in their backup environment. They now want to install an Dell Avamar server and monitor all products from a single console.

Which software would you recommend?

For which situation is the adaptorctl.pl command used?

When using YAST to set up networking on a Gen4 Avamar node, how do you backspace in a field?

According to Dell best practices, what is the maximum percentage of physical RAM that should be allocated for the hash and file caches combined?

Due to a scheduling conflict, an Dell Avamar administrator had to cancel the backup of a client using the Avamar Administration GUI. What happens to the backup data that had already been sent to the Avamar server?

The Dell Avamar client needs to backup a file and has performed sticky-byte factoring. This results in the following:

Seven (7) chunks that will compress at 30%

Four (4) that will compress at 23%

Two (2) chunks at 50% compression

How many chunks will be compressed prior to hashing?

Which size Avamar Gen4 storage node is supported for a RAIN configuration?

How many hours does the benchmark test run in an Dell Avamar Virtual Edition install?

What is the maximum number of backups that can be running per Avamar storage node in order for HFS check to initiate successfully?

Which feature is available through the Avamar Enterprise Manager, but not available through the Administrator console?

Which Dell Avamar Management Console navigation screen can be used to check when the last checkpoint and checkpoint validation occurred?

What is the last step in the hardware installation portion of an Dell Avamar multi-node deployment?

At which percentage of OS capacity does Dell Avamar garbage collection stop running?

What is the maximum number of nodes currently available in an Avamar server?

Which type of Dell Avamar Gen4S node supports SAS drives?

During Dell Avamar garbage collection, which backups are candidates for deletion?

What is used by Dell Avamar to provide system-wide fault tolerance?

Which basic network settings are required when configuring an Dell Avamar node at installation?

What is the physical memory requirement for an Dell AVE with 1 TB capacity?

On an Dell Avamar server, what is the file extension of stripes that contain backup chunks?

A customer has a remote client with over 4 TB of file data that needs to be backed up to a local Avamar server.

What is a best practice to perform the initialization?

A company wants to compare the amount of Avamar storage that a Microsoft Windows file server client consumes with that of a UNIX DB2 server. Which tool can be used to determine the amount of Avamar storage used by a particular client?

A storage node in a multi-node Dell Avamar server has failed, and a full node replacement is being performed.

What is used to reconstruct the data on the replacement node?

What is a characteristic of an Dell AVE?

Which Dell tool provides all the necessary steps, in the correct order, to implement an Dell Avamar server?

When accessing the utility node using a bash shell (putty) session as `admin', you receive a message referencing a possible Man-In-The-Middle attack stating:

"REMOTE HOST IDENTIFICATION HAS CHANGED!"

How do you repair this condition?

Which factor(s) affect the capacity utilization in an Dell Avamar environment?

Which command is used to convert new Avamar nodes to storage nodes?

A company using Dell Avamar wants to delete a backup from their grid during the end of the maintenance window. However, they are not able to delete it.

What may prevent the backup from being deleted?

By default, what percentage of file system storage space is reserved for operating systems and checkpoint overhead on an Dell Avamar server?

A company wants to back up their Dell Celerra to their Avamar server. Where is the Avamar backup client software installed?

What would you run to determine if your Dell Avamar server is running in a steady state?

By default, what does the Avamar Email Home profile send?

What is the maximum number of simultaneous backups that can be performed using an Dell Avamar NDMP accelerator with 32 GB of RAM for Dell Celerra DART 6?

An Dell Avamar customer is analyzing the DPN Summary report shown in the exhibit.

What does the field "TotalBytes" represent?

An Dell Avamar Gen4 server has arrived at a customer's site. You begin reviewing the hardware for an Avamar 6 installation. You find that two of the five nodes are Gen3 running RHEL OS and the others are running SLES OS.

Can you proceed with the install?

A customer site requires five network connections into their Gen4 Avamar Data Store (ADS) Server utility node. However, you observe that none of the Gen4 nodes in the server rack have more than four Ethernet connections on their rear panel.

What will you tell the customer?

In which ways can Avamar Replication be configured?

Your readiness checks show that a customer's Gen4 Avamar server has entered a read-only status. To avoid data loss, which recommended state should the Avamar server be in before you can continue the "Add Node" procedure?

Which factor has the most impact on checkpoint overhead for an Dell Avamar server?

Which command is used to prevent new client activities from starting on an Dell Avamar server?

A Microsoft Windows user is about to initiate an on-demand backup from the client interface when the utility node fails on their multi-node Dell Avamar grid. What must be done prior to initiating the backup to ensure the backup will complete successfully?

On an Dell Avamar server, the maintenance schedule is enabled. If the server is over a certain capacity, when will the server automatically cancel backups that are running under the default configuration?

An Dell Avamar Virtual Edition server is created using thin provisioned virtual disks. What effect will this have instead of using thick provisioning?

An Dell Avamar backup administrator is logged in as root. The administrator is running a mapall date command to all nodes, all of which respond with a password prompt.

Which SSH keys need to be loaded?

In Dell Avamar 6.0, which tool is used to completely move clients to a new Avamar server?

Which Information is required when registering an Dell Avamar environment to IBGroup?

A customer has received an Avamar Gen4 Data Store. They want the software version on the new system to match their existing Avamar 5.0 system.

What do you tell the customer?

Which size Avamar Gen4 node has 100 GBs of SSD storage?

When a backup is initiated by the Dell Avamar client application, how is the retention determined?

You are configuring standard replication for a source Dell Avamar system, Avamar1, under the clients domain. The configuration is successful, and the client inquires about where the replicated clients appear on the target Avamar system.

Which domain contains the source clients on the target system?

An Dell Avamar server is integrated with an Dell Data Domain system. A backup has expired on the Avamar server and garbage collection runs.

What is the impact to the backup stored on the Data Domain system?

A company wants to compare the amount of Avamar storage that a client of a Microsoft Windows file server consumes with that of a UNIX DB2 server.

Which tool can be used to determine the amount of Avamar storage used by a particular client?

Which process divides the data into chunks for Dell Avamar deduplication data flow processing?

According to Dell Avamar best practices, the backup window duration specified on a backup schedule should not exceed how many hours per day?

Which Dell Avamar replication mode allows for many-to-one and bi-directional replication?

An Dell customer has a backup environment with the following characteristics:

Multi node Avamar Data Store version 7.0

Image-level backups for VMs with VADP

Integration with Dell Data Domain

File system backups stored in Avamar

Database and VM images backed up to Data Domain with Avamar

What benefit does the customer have with this setup?

What is an advantage of the Dell Avamar deduplication technology?

Which port on the Dell Avamar server does a client connect to when performing backups?

Which user account and default password should be used when configuring an additional Dell Avamar server in Enterprise Manager?

At which percentage of user capacity will Dell Avamar issue the first warning?

On a single-node Gen4 Dell Avamar Data Store, what is the optional use of the GB2 port?

When sizing a large database server on an Dell Avamar, how many bytes per entry are added to the hash cache?

An Dell Avamar storage administrator has 400 Microsoft Windows clients; 350 are production and 50 are development. The administrator wants to replicate only the production servers.

If repl_cron.cfg is changed to exclude only the development servers, what will be replicated?

What is an advantage of performing VMware Image Level backups with Dell Avamar?