D-PST-OE-23 Dell PowerStore Operate 2023 Exam Questions and Answers

Reboot node B

Clear the boot mode

Disable node B boot mode

Return node A to normal mode

Additional VLTi links on the ToR switching must be configured for the 9000T to support the increased inter-switch network load

Add the new 9000T appliance into the cluster per the procedure; mixed models of the same type are supported

Remove two of the four NVMe NVRAM drives from the 9000T the caching configuration of all clustered appliances must match

The new appliance cannot be added to the cluster; appliance model and type must match when clustering appliances together

X systems have higher heat dissipation specifics than T systems

Higher model numbered systems have lower heat dissipation specifications than lower model numbered systems

T systems have higher heat dissipation specifics than X systems

Lower model numbered systems have lower heat dissipation specifications than higher model numbered systems

3000

5000

7000

9000

Battery backup unit

Embedded I/O module

Memory module

4-Port mezzanine card

Ignores log messages from the specified date

Retrieves log messages from the specified date

Deletes all logs before the specified date

Rotates the log based on the specified date

1

2

3

4

2

1

3

4

Base enclosure

Expansion enclosure

Battery Backup Unit

Nodes

If FRU does not contain ESD-Kit, continue without it

Order “Emergency ESD-Kit” ASAP

Follow precautions described in the “Emergency Procedure”

Use package material to build “provisional ESD-Kit”

Retrieves log messages from the specified error and watches for re-occurrence

Ignores log messages from the specified error and re-occurring errors

Rotates the log based on the specified error

Deletes all logs before the specified error

SAS cabling goes from existing A ports to new В ports. At the last enclosure, SAS cabling returns from the A ports to the originating node’s B ports

SAS cabling goes from existing A ports to new В ports. At the last enclosure, SAS cabling returns from the A ports to the alternate node’s В ports

SAS cabling goes from existing В ports to new A ports. At the last enclosure, SAS cabling returns from the В ports to the alternate node’s A ports

SAS cabling goes from existing В ports to new A ports. At the last enclosure, SAS cabling returns from the В ports to the originating node’s A ports

Expansion enclosure faulted

SAS bus link up

SAS bus link down

Expansion enclosure power-on

10 GigE Cat 6 Ethernet RJ-45

25 GigE Twinax

100 GigE QSFP28

10 GigE SFP optical cable

System is booting

Module is faulted

Node is faulted

Cluster is uninitialized

3

4

2

1

4-Port Mezz card

SFP

M.2 Device

LCC

Discover new drive

Rebuild activity

Faulted drive

Normal activity

Configure a port for the discovery laptop

Create VLANs for NAS servers

Create node A port-channel

Configure LACP uplink to management switch

VLAN 1 and VLAN 1501 pass tagged traffic

VLAN 1 passes tagged traffic, VLAN 1501 passes untagged traffic

VLAN 1 passes untagged traffic, VLAN 1501 passes tagged traffic

VLAN 1 and VLAN 1501 pass untagged traffic

Base enclosure hardware is operating normally

Base enclosure has a component hardware fault

Cluster has only a single appliance

Appliance has a node in service mode

The system is booting

Nodes are in service mode

The system is not initialized

Nodes are in degraded mode