DEA-5TT2 Associate – Networking Version 2.0?(DCA) Questions and Answers

The IEEE separates the Data Link and Physical ISO layers into four sub-layers. Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?

What are the Protocol Data Units (PDUs) called at the Transport layer?

A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces?

What is the default route preference value for a Border Gateway Protocol (BGP) internal route?

What accurately describes OSPF?

Which Layer 1 device can be used to enlarge the area covered by a single LAN segment?

Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?

Which option is used to configure Network Address Translation (NAT) to provide one-to-one mapping between local and global addresses?

What are Network Address Translation (NAT) inside global addresses?

Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

What accurately describes IPv6 addressing?

Refer to the exhibit.

Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?

Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

What is the correct sequence of steps when a web browser accesses a web server?

Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?