DES-DD33 Specialist - Systems Administrator PowerProtect DD Exam Questions and Answers

What is the correct sequence of steps to configure storage for Dell EMC Cloud Tier in the DD System Manager?

What information does the daily Autosupport report contain?

Which command is used to check if NFS is enabled?

An administrator is migrating their old cloud tier-enabled Data Domain to a new PowerProtect DD appliance with cloud tier. During migration, the administrator recognizes that file system cleaning on the source system is not possible.

What is the most likely cause of this behavior?

What are some possible network bottlenecks for a PowerProtect DD?

An administrator is scaling Cloud Tier for a DD9400 by adding a second cloud unit.

What is the required amount of metadata storage (ТВ)?

A storage administrator finished the zoning between the PowerProtect DD and the NetWorker backup server.

How can they verify that the zoning was completed properly and the server HBA are visible?

A backup administrator is tasked with monitoring PowerProtect DD capacity metrics. The administrator is backing up 2 ТВ of data daily with a reduction rate at 5x. After data reduction, subsequent full backups compress down to 100 GB.

The initial backup requires 400 GB with a 10 percent increase in the data each day. Each incremental backup is 200 GB. After data reduction, each incremental backup is 20 GB.

What is the weekly burn rate (GB) after six daily incremental backups and one weekly backup?

Which protocol is used for communications between a PowerProtect DD appliance and cloud tier to Dell EMC ECS?

What is a requirement to configure the PowerProtect DD tape out to cloud feature?

Which statement is correct regarding backup flow without PowerProtect DD?

How many hops should the fabric configuration be limited to when implementing the DD VTL?

Where is the DD System Manager can the status of chassis components be found?