If you can ping the peer host successfully, which of the following methods is the most appropriate for subsequent troubleshooting?
Which of the following does not require customers' signing in a migration project?
During unpacking and inspection, the device appearance is intact and all modules work properly after the first power-on. After the device continuously runs for 24 hours, a fault occurs on a card. This situation does not conform to DOA conditions.
If a neighbor has not advertised a route, the neighbor may have not put description information about the route to the local OSPF LSDB.
Which of the following causes may result in a BGP peer relationship fault? (Multiple Choice)
After finding that the OSPF configuration on a router is incorrect, you logged in to the router to check the OSPF configuration. Then you found that the association between OSPF and BFD was also incorrect. Therefore, you changed the OSPF and BFD configuration. Which of the following troubleshooting methods is used in this process?
Which of the following cabling modes are commonly used in a data center? (Multiple Choice)
, well behaved, and appropriate in language use. When communicating with customers, Huawei engineers need to be groomed
Which of the following statements regarding Huawei network optimization service (NOS) is false?
Which of the following causes for a VRRP group two-master fault is the most impossible?
In most cases, a risky operation solution can be reviewed and finalized one day before implementation.
During the structured network troubleshooting process, in which of the following phases is the fault reported or advertised to other departments? (Multiple Choice)
Customer network information and service composition are business secrets of customers and cannot be leaked, obtained without authorization, or sold for operation.
During the structured network troubleshooting process, which of the following statements regarding the fault identification phase is true?
Which of the following networks are involved during construction of a large enterprise network? (Multiple Choice)
As shown in the figure, the GE0/0/0 and GE0/0/1 interfaces of RTA are respectively connected to department 1..2, and their network segments are respectively 10.1.2.0/24 and 10.1.3.0/24, which are restricted departments Questions between 1 and 2, when deploying traffic-filter on RTA, which options are positive for the following deployment methods?
The structured network troubleshooting process is triggered by a fault report. The basic principle is to simplify troubleshooting by narrowing down or isolating all possible causes of a fault into several small subsets. In what sequence are structured network troubleshooting steps carried out? 1. Information collection 2. Fault identification 3. Cause list 4. Troubleshooting assessment 5. Fault analysis 6. One-by-one check 7. Fault rectification
The migration kick-off meeting is held to communicate with the customer about the project. Communication with other involved parties is not important.