HPE6-A72 Aruba Certified Switching Associate Exam Questions and Answers

Starts an automatic page scrolling effect that pauses for a few seconds every 30 rows.

Enables a terminal notification when a new debug event occurs for L2MAC events.

Shows a new terminal window opening to allow typing while debugging occurs.

Results in a page break to disable the default continuous scrolling In the console.

10/100 Megabit Ethernet, Gigabit Ethernet, and 100 Gigabit Ethernet

Gigabit Ethernet, 25 Gigabit Ethernet, and 40 Gigabit Ethernet

10/100 Megabit Ethernet, Gigabit Ethernet, 25 Gigabit Ethernet, and 100 Gigabit Ethernet

10/100 Megabit Ethernet, Gigabit Ethernet, and 40 Gigabit Ethernet

a machine learning method of packet inspection for the purpose of choosing which dynamic routing protocol to automatically assign

a concept that applies to firewalls, when examining packets only up through Layer 4

a function of Policy Based Routing that examines the entire IPv4 header to forward traffic based on factors other than destination address

a firewall process of examining the packet header all the way to Layer 7 in order to determine if the packet should be permitted or denied

Aruba 8400

Aruba 8408

Aruba 6410

Aruba 5412r

Core-1(config)# no ssh server Core-1(config)# no https-server

Core-1# no ssh server vrf default Core-1# no https-server vrf default

Core-1(config)# no ssh server enable Core-1(config)# no https-server enable

Core-1(config)# no ssh server vrf default Core-1(config)# no https-server vrf default

802.1Q

IPSec

STP

RIP

802.11af

a pair of fiber optic strands allowing transmit on one and receive on the other at the same time

a mobile phone call

point-to-point connections between two switches allowing concurrent transmit and receive

CB radio using push-to-talk

Alternate

Backup

Root

Designated

The command page

The command terminal length 30

The command more

The command less

Core(config)# https-server rest access-mode read-write

Core(config-if-mgmt)# no shutdown

Core(config-if-mgmt)# no tftp-server

Core(config-if-mgmt)# enable

Core(config)# https-server rest access-mode read-only

UDP 1812 and UDP 1813

UDP 161

TCP 443

UDP 162

Access-1(config)# interface 1/1/1

Access-1(config-if)# routing

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

Access-1(config)# interface 1/1/1

Access-1(config-if)# vlan trunk permit vlan 100

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address static 10.1.1.1/24

Access-1(config)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

Access-1(config-if)# vlan 100

Access-1(config-vlan)# ip address 10.1.1.1/24

STP

802.11af

RIP

802.1Q

IPSec

Management interface split detection

Peer switch-based detection

Loopback keepalives

ARP-based

BFD

SSID

DNS server IP

Subnet Mask

LLDP-MED

VLANID

Router ID

Priority

Hello and Dead intervals

Area ID

Process ID

show vsf member

show vsf link

show vsf topology

show vsf detail

SNMPv2c

HTTPS

USB-C console

Telnet

SSH

Layer 2 and Layer 3 protocols run close to the endpoints to better implement ACL and QoS policy at the edge.

Improved performance by offloading processing from the Access layer to the Core.

Use of layer 2 switches at the access layer can process and route traffic from attached APs.

Support for WAN/MPLS, Internet, and Data Center directly on the Collapsed core.

Provides a more cost effective solution given that no additional switches are required for a third tier.

Offloading processing from the Core without routing at the Access layer.

Can use lower speed links between Core to Aggregation and Aggregation to Access given the use of an Aggregation layer.

Lowering the cost of a deployment due to needing less switches overall.

Better scalability in a campus with a large number of buildings.

Gaining the flexibility to connect the Data-Center to any Access layer switch.

show secondary

show version detail

show version

show images

Aruba 6405

Aruba 2930F

Aruba 8400

Aruba 5406R

Aruba 8350

designed to avoid routing entirely and to have Layer 2 remain across Core, Distribution, and Access layers

divides the Core into two layers (Core and Aggregation) with the Access Layer only handling PoE and Access Control

includes a Distribution Layer to provide Layer 3 features between a routed Core and a Layer 2 Access edge

divides the network into two layers (Access and Core) with the option of routing to the Access Layer

AOS-CX VSF links can only be applied to uplink ports with 10G, 25G. and 50G speeds.

VSF Is not possible between CX 6300M and CX 6300F AOS-CX switches.

Link 1 cannot be used if the attached CX 6300F VSF member 2 has already assigned link 1

The port1/1/21 has been shutdown