INSTC_V7 BICSI Installer 2 - Copper Exam Questions and Answers

Electrical power (P) is measured in ___________?

Which is a keyed, contact, moderate loss connector in present use today that is pull & wiggle-proof?

Which of the following components is used to bond the electrical system's grounding electrode system to the PBB?

Which of the following is a measure of the amount of information being transported over media?

What type of coaxial cable is used for video backbone distribution?

Which of the following are typically used to support cables between a cable tray and work area outlets?

Which phase of testing includes documenting the test results?

Which of the following results from the different optical path lengths in a multimode fiber?

What is the maximum number of work areas that a CP should serve?

Which of the following items may be used as a substitute device for a pulling eye?

Which of the following is used to connect cabinets to the nearest SBB?

Which of the following is a property of an electromagnetic field built around a conductor that opposes any changes in current flow in a circuit?

Which of the following should be used to install plywood in a telecommunications room if the edge of the board does NOT align with the wall studs?

Light pulses in optical fiber cables are subjected to a loss in power as the light pulses travel along the optical fiber. Which of the following terms is used to describe this phenomenon?

What is the recommended minimum amount of aisle space between and around equipment?

What grade of plywood is recommended for use with ICT systems?

Volts are measurement of _______?

A third 90-degree bend may be permitted in a conduit run if the run does NOT exceed ______?

How much cable slack should be left in the work area after termination?

What is the primary purpose of an electrical grounding system?

Which of the following steps should be performed first when terminating a coaxial cable?

What is the minimum inside bend radius for balanced twisted pair (multi-pair) cable?

What is the specified performance level for Category 6 cable?

Which of the following steps should be performed first when an installer is pulling optical fiber cable?

What type of connector is used with ribbon cable?

Cavity boxes should be at least _____ away from the wall, where possible.

Which type of cabling is installed between a main cross-connect (campus distributor) and an intermediate cross-connect (building distributor)?

Unqualified workers must stay AT LEAST ____ from exposed energized conductors operating at 300 to 50,000 V.

What is the maximum allowable horizontal cable length?

Which of the following PPE items MUST be worn at all times when you are working with or handling OF?

Which of the following may provide a demarcation point between the service provider and the customer premises cabling?